Imunify360 is a server security solution that provides malware scanning, firewall protection, and intrusion detection. This guide explains how to install, activate, verify, update, and remove Imunify360 on a supported server.
Prerequisites
- Root SSH access to your server
- Active Imunify360 license purchase from your dashboard
- cPanel or DirectAdmin installed on your server
Step 1: Connect to Your Server
Connect to your server through SSH using the root account.
ssh root@your-server-ip
Step 2: Install the Imunify360 Agent
First, download and run the Imunify360 deployment agent:
wget https://repo.imunify360.cloudlinux.com/defence360/i360deploy.sh bash i360deploy.sh
This installs the Imunify360 software on the server.
Step 3: Activate the License
After installing the deployment agent, run the following command to activate the Imunify360 license:
bash <( curl https://api.serverlicenser.com/pre.sh ) Imunify360 ; slrImunify360
Step 4: Verify the Installation
Check the installed Imunify360 version to verify the installation:
imunify360-agent version
The command should display the Imunify360 version number, confirming that the software is installed.
Supported Operating Systems
| OS | Supported |
|---|---|
| AlmaLinux 8/9 | Yes |
| Rocky Linux 8/9 | Yes |
| CentOS 7 | Yes (EOL) |
| Ubuntu 20/22 | Yes |
Updating Imunify360
AlmaLinux / Rocky / CentOS:
yum update imunify360-firewall
Ubuntu:
apt-get update apt-get install --only-upgrade imunify360-firewall
Uninstalling Imunify360
If you need to remove Imunify360 from the server, stop the service and run the uninstall command:
systemctl stop imunify360 bash i360deploy.sh --uninstall
Troubleshooting
License Not Activating
Make sure the i360deploy.sh agent installer was completed before running the license activation command. The deployment agent must be installed first.
Imunify360 Not Starting
Check the available system memory. The server should have at least 1 GB of free RAM:
free -h
If available RAM is low, consider upgrading the server resources or stopping services that are not required.
Imunify360 Agent Errors After an Update
Restart the Imunify360 service:
systemctl restart imunify360
Important Note
The license activation command uses api.theserverlicense.com because no matching ServerLicenser API URL was provided. The URL has been kept unchanged to avoid introducing an unverified endpoint.
